Please make sure the following dip switches are set as follow:
SW 1 – OFF
SW2 – OFF
SW3 – ON
SW4 – ON
Re-initializing a V-Core to Discovery Mode
- Grab your V-Core under Test and set DipSw #3 to the off position and wait about 1 min.
- Move sw3 to the On position and remove the power from the V-Core.
- Power on your V-Core. (at this point your device will be under the following network settings)
192.168.5.254 , SubNet 255.255.255.0
- Move SW 1 to the On position and power down your V-Core.
- Move SW 1 to the off position and power up your V-Core.
- Wait a minute and your V-Core will be in Discovery Mode.
Now follow the steps from this link: