A firmware update can be done via AMI Terminal or using a Dip Switch configuration.
If it's done via AMI Terminal the VPAGE will remember the last known IP; open your web browser and enter the IP address hit enter to refresh the page and the Firmware Update Mode will be shown.
When it's done with the Dip Switch #2 set to On, the VPAGE will always boot on 192.168.0.254 IP address; open your web browser and enter 192.168.0.254 and hit enter to refresh the page so the Firmware Update Mode page can be seen.
In some cases the arp table has to be cleared. Launch your command prompt application (cmd.exe) and enter the command arp- d